Outer Tie Rod End Left / Right – Honda Prelude 1988–1991 – 555 SE-6161

This outer tie rod end by 555 is an aftermarket steering part for Honda Prelude 1988–1991. It is designed to fit either left or right side, which helps simplify part selection for this application.

The product is manufactured by 555 and cross-references Honda OEM number 53540-SF1-004. OEM numbers are provided for reference purposes only, to help identify the correct part. This product is manufactured by 555, not Honda.

Applications

• Honda Prelude – 1988–1991
• Position: outer tie rod end
• Side: left or right

If you are unsure about fitment for a specific market version or chassis variant, VIN verification is recommended before ordering.

OEM Reference Numbers

OEM numbers are provided for reference purposes only, to help identify the correct part. This product is manufactured by 555, not Honda.

• Honda OEM reference: 53540-SF1-004

When to Replace / Symptoms of Wear

• Play felt in the steering linkage
• Knocking or clicking noise from the front suspension / steering area
• Reduced steering precision
• Uneven front tyre wear
• Visible damage to the dust boot or loss of grease

If one side is worn, inspect the opposite side as well. Parts on the same axle are often replaced in pairs when wear is similar.

Installation and Service Tips

• Confirm the old part matches the new one before installation.
• Check the condition of the inner tie rod and dust boots during service.
• After replacement, wheel alignment is recommended.
• Tighten all fasteners correctly according to the workshop manual for the vehicle.

FAQ – frequently asked questions about Outer Tie Rod End Left / Right – Honda Prelude 1988–1991 – 555 SE-6161

Is this part for the left or right side?
This 555 SE-6161 tie rod end fits both left and right side for the listed Honda Prelude application.

Is this a genuine Honda part?
No. This is an aftermarket part manufactured by 555. The Honda number 53540-SF1-004 is listed only as an OEM cross-reference.

Will I need wheel alignment after replacing it?
Yes, wheel alignment is recommended after tie rod end replacement.

Can I replace only one side?
Yes, but if the opposite side shows similar wear, replacing both sides together is often the better service approach.